PCM BO26-RSE-110M-IK Mode D'emploi page 2

English
1. To fix the tool holder on the
machine, introduce the shank and
use the pin for positioning. Tighten
the 6 fixing screws (important, make
sure that the screws have the same
clamping force).
Zone industrielle C
Rte du Grammont 101
CH-1844 Villeneuve
Mode d'emploi
Operating instructions
Betriebsanleitung
Istruzioni per l'uso
BO26-RSE-110M-IK
PCM WILLEN SA
SWISS MADE
Copyright © PCM Willen SA.
Garant:
RBT
Validation : 04.03.2019
2. Adjust the offset of the position.
3. During the mounting or the dismounting
of your cutting tools, block the broach
on flats planned for that purpose.
4. The tool shank diameter should never
have a difference of more than 0.4 mm
compared to the clamping diameter of
collet.
Example: clamping diameter 9.5 mm =>
Shank diameter 9.1 mm minimum.
MARK : Never use the tool holder with
empty positions.
protection plug.
Tél ++41 21 967 33 66
Fax ++41 21 960 38 95
email:
Document :
BO26-RSE-110M-IK
Mode d'emploi
Page : 2 de 4
Use the supplied
http://www.pcm.ch
office@pcm.ch