Table des Matières
Publicité
Auxiliary outlet
(constant power)
Used for accessories such
as WiFi routers, teacher
laptops, or printers.
Specifi cations:
Input:
125V~/12A, 60Hz
Max output:
125V~/12A, 60Hz
Breaker:
15A, 250 VAC
Cycling Interval:
15 minutes
Cycling outlets:
4 timed internal (A, B, C, D) up to 10A
Auxiliary outlets:
1 external, 1 internal, 1A each
(controlled by main on/off switch)
Power cord:
IEC quick-release (replaceable)
15' nominal, 14 AWG, 3-wire
Power switch:
15A, rocker, red-lighted
Indicator lights:
4 Green LED
Enclosure material: 16 gauge steel
Mounting type:
Screw / stud
Dimensions:
12.75"W [324mm] x 7.29"D
[185.2mm] x 1.5"H [38.1mm]
Regulatory listing:
ETL recognized (certifi ed to 60950-1)
PowerProdigy
External side view
(external access)
LED lights indicate
charging activity status
of power units
Internal side view
(internal access)
Outlets for power unit plugs
Smart charging senses current and relays
power to the power units requiring it most.
Features:
• The PowerProdigy
and distributes power (up to 10A) to the least-charged devices fi rst. This sensing /
switching occurs every 15 minutes. If no devices are plugged into a power unit, the
charger skips that power unit and goes onto the next one.
• No adjustments by the user are needed
• If overall amp draw is low enough (below 10A), the charger will send power to all
available power units
• Four LED lights indicate charging activity status of each power unit. Lights
remaining on continuously indicate power is being provided to all four banks.
• Prevents electrical overload in older classrooms
• Diagnostic-capable mode
• 1A auxiliary outlets (one internal, one external) remain on while the unit is powered
on, and can be used (even during charging cycles) to power accessories like a
teacher laptop or Wi-Fi access point
• External power switch
• Auxiliary outlets are for peripheral use only. Do not use auxiliary outlets to
charge multiple laptops or devices. (Use cycling outlets A, B, C, D for charging.)
• Switch the timer power switch OFF before unplugging or plugging-in the main power unit cords
• Total equipment load not to exceed 12-amps per power unit.
• Do not plug the power cord into an extension cord.
• Inspect power cord before each use. Do not use power cord that is damaged.
• Do not unplug by pulling on the cord.
• Do not step on, drive over, drag, or place objects on the power cord.
• For indoor use only. Do not install or store the unit where it will be exposed to
moisture. Keep dry.
• For added safety, plug the timer into a grounded three-prong receptacle controlled
by a GFI (Ground Fault Interrupter) circuit breaker.
™
System
IEC power
cord inlet
charger senses current from up to four, 10-outlet power units
™
CAUTION
Power switch
Auxiliary outlet (constant power)
Used for accessories such as Wi-Fi
routers, instructor laptops, or printers.
0117670R7 Page 12 of 23
Publicité
Table des Matières
