Pro-Ject Audio Systems Speaker Box 10DS2 Mode D'emploi page 12

Technical specifications Pro-Ject Speaker Box 10DS2
Recommended amplifier power: 15 to 150 watts RMS
Potential incorrect use and fault conditions
No signal on one or both channels:
Make sure that amplifier is turned on and source is working properly.
No connection between speaker and amplifier. This could be due to a faulty plug, broken wire
or or simply loose plug/socket connection.
Service
Should you encounter a problem which you are not able to alleviate or identify despite the
above information, please contact your dealer for further advice. Only when the problem
cannot be resolved, the unit be sent to the responsible distributor in your country.
Warranty
The manufacturer accepts no responsibility for damage caused by not adhering to these
instructions for use. Modification or change to any part of the product by unauthorized persons
release the manufacturer from any liability over and above the lawful rights of the customer.
For more information about Pro-Ject and Box Design, see our homepage:
http://www.project-audio.com
12
©Pro-Ject Audio Systems • Pro-Ject Speaker Box 10DS2 • Revision
Enclosure type: bass reflex via rear port
Frequency response: 45Hz - 20kHz
Nominal impedance: 4 ohms
Sensitivity: 88dB (1w /1m)
Chassis: 1" silk dome tweeter
Dimensions W x H x D: 160 x 898 x 195 mm (excluding spike feet)
Weight: 12,8kg / piece
5" plycone bass/mid (2 pc.)