Maintenance And Care; Brush Replacement - Yamabiko MTA-PS Manuel D'utilisation

Maintenance and care

Brush replacement

4. Pull flexible cable from the drive shaft housing, wipe clean
and re-coat with a thin coating 15 ml of Lithium based
grease.
5. Slide the flexible cable back in the drive housing. Do not get
dirt on the flex cable.
6. Position lower drive shaft (end without safety decal) into gear
housing shaft mount.
7. Align hole in drive shaft housing with gear housing shaft hole
(C), and seat lower drive shaft end into gear housing shaft
mount.
8. Install and tighten locator screw (A).
9. Tighten gear housing mounting bolt (B).
Brushes that are broken off, deformed, or worn to within 25.4 mm
of the brush holder drum should be replaced for best sweeping
efficiency.
1. Locate brush holder access hole (A) near outer drum end.
2. Hold 8 mm nut (B) from turning with open end wrench insert-
ed through drum holder cap.
3. Loosen and remove bolt and lock nut with cross head screw-
driver through holder access hole (A).
4. Remove drum cap (C). Slide brush holder drum off square
axle shaft.
14