JVC KD-X360BTS Manuel D'instructions page 41

TROUBLESHOOTING
Symptom Remedy
"CHECK ANTENNA" Check that the antenna and its connection are in good
condition.
"CHECK TUNER" Make sure the SiriusXM Vehicle Tuner is connected to the
unit.
"NO SIGNAL" Make sure the antenna is mounted outside the vehicle.
"SUBSCRIPTION UPDATED Your subscription is updated. Press the volume knob to
– PRESS ENTER TO continue.
CONTINUE."
"CODE ERROR" Make sure you have entered the correct pass code.
(Page 14)
"NO CONTENT" There is insufficient content to start TuneScan.
"SCAN CANCEL" TuneScan has been aborted.
No Bluetooth device is • Search from the Bluetooth device again.
detected. • Reset the unit. (Page 3)
Pairing cannot be made. • Make sure you have entered the same PIN code to both the
unit and Bluetooth device.
• Delete pairing information from both the unit and the
Bluetooth device, then perform pairing again. (Page 15)
Echo or noise is • Adjust the microphone unit's position. (Page 15)
heard during a phone • Check the [ECHO CANCEL] setting. (Page 17)
conversation.
Phone sound quality • Reduce the distance between the unit and the Bluetooth
is poor. device.
• Move the car to a place where you can get a better signal
reception.
Symptom Remedy
Voice calling method is not • Use voice calling method in a more quiet environment.
successful. • Reduce the distance from the microphone when you speak
the name.
• Make sure the same voice as the registered voice tag is
used.
Sound is being interrupted • Reduce the distance between the unit and the Bluetooth
audio player.
or skipped during playback
of a Bluetooth audio player. • Turn off, then turn on the unit and try to connect again.
• Other Bluetooth devices might be trying to connect to the
unit.
The connected Bluetooth • Check whether the connected Bluetooth audio player
audio player cannot be supports Audio/Video Remote Control Profile (AVRCP).
controlled. (Refer to the instructions of your audio player.)
• Disconnect and connect the Bluetooth player again.
"PLEASE WAIT" The unit is preparing to use the Bluetooth function. If the
message does not disappear, turn off and turn on the unit,
then connect the device again.
"NOT SUPPORT" The connected phone does not support Voice Recognition
feature or phonebook transfer.
"NO ENTRY"/"NO PAIR" There is no registered device connected/found via
Bluetooth.
"ERROR" Try the operation again. If "ERROR" appears again, check if
the device supports the function you have tried.
37
ENGLISH