Removing Collected Water - Danby DDR030BBCWDB Guide D'utilisation Et D'entretien

Operating Instructions

REMOVING COLLECTED WATER

1. Pull out the bucket a little.
2. Hold both sides of the
bucket with even strength and
pull it out from the unit.
3. Pour the water out.
If the pump hose drops when you
remove the bucket, ensure it is reinstalled properly.
Remove the plastic
cover by turning it
counter-clockwise.
Drain hose
There are two ways to remove collected water:
1. Use the bucket
When the bucket is full, the unit will beep 8 times and the bucket full indicator
light will fl ash. The compressor will turn off and the fan will turn off after drying
the water on the condenser for 30 seconds.
To empty the full bucket, grip the left and right handles securely and carefully
pull it straight out so water does not spill. Do not put the tank on the fl oor be-
cause the bottom of the bucket is uneven; the bucket will tip over and cause
water to spill. Discard the water and return the bucket to the unit. The bucket
must be properly positioned for the dehumidifi er to operate. The machine will
restart when the bucket is restored in its correct position.
Note: When you remove the bucket, do not touch any parts inside of the unit.
Doing so may damage the product. Be sure to push the bucket gently all the
way into the unit. Banging the bucket against anything or failing to push it in
securely may cause the unit not to operate. When you remove the bucket, if
there is some water inside the unit you must dry it. The bucket full light fl ash-
es when the bucket is not properly in place.
2. Continuous draining:
Water can be automatically emptied into a fl oor drain by attaching the unit
to an ID ≥ 5/16" water hose with a ID:M=1 female threaded end. Hose not
included, a standard garden hose works well.
To install the drain hose fi rst remove the plastic cover from the back drain
outlet of the unit and set it aside. Install the female threaded end of the
water hose into the adaptor A, then lead the water hose to the fl oor drain or
a suitable drainage facility. Make sure the hose is secure so there are no
leaks. Direct the hose toward the drain, making sure that there are no kinks
that will stop the water from fl owing. Place the end of the hose into the drain
and make sure the end of the hose is level or declining to let the water fl ow
smoothly. Select the desired humidity setting and fan speed on the unit for
continuous draining to start.
Note: There is no drain pump in this unit, water is drained by gravity only.
Ensure that the drain hose is angled downward so that water does not back
up into the bucket.
8