Removing Collected Water; Water Level - Danby DDR3011 Guide D'utilisation Et Soins De Propriètaire

When using the dehumidifier always make sure the water bucket is locked into place.

REMOVING COLLECTED WATER

There are 2 ways to remove collected water:
Use the bucket. When the bucket is removed,
1
the unit will shut off. Empty and replace the
bucket.
NOTE: Support bucket with both hands when
emptying.
IMPORTANT
Do not use the hose if you are using the bucket to
collect water. When the hose is connected, water
will flow through it onto the floor instead of into
the bucket.
NOTES
• Do not remove the bucket while the dehumidifier is
operating or if it has just stopped operating. This
might cause some water to drip from the drain pan.
• The bucket must be in place and securely seated for
the dehumidifier to operate.

WATER LEVEL

The dehumidifier will turn off automatically when the
bucket is full, or when the bucket is removed or not
replaced in the proper position.
The bucket must be replaced in the proper position for
the dehumidifier to work. The light will be on and the
dehumidifier will not run if the bucket is not in the
proper position.
OPERATING INSTRUCTIONS
Use a hose. Water can be automatically emptied
2
into a floor drain by attaching a garden water hose
(not included).
1. Remove the bucket from the front of the unit.
2. Open the drain cover on the side of the unit.
3. Thread a garden hose (not supplied) onto
the nozzle, cut to length, and lead it to the
floor drain.
NOTE: Use a hose that is no more than 5ft in
length and make sure it has a downward slope
going into the floor drain.
4. Replace the bucket in the unit.
NOTE: The bucket must be in place and securely
seated for the dehumidifier to operate.
5
Side of uniit
Side of uni