Description And Technical Specifications - Fiamma Bi-Pot 30 Instructions De Montage

EN OPERATING AND MAINTENANCE INSTRUCTIONS

1. DESCRIPTION AND TECHNICAL SPECIFICATIONS

Article : Portable chemical toilet with two detachable tanks.
Material: Solid synthetic material - can be recycled.
Suggested detergents:
2. OPERATION
Separate the two tanks by releasing the side-clips. Fill the upper tank with max.
13 (10 BP 30 ) litres of water.
This amount of water is sufficient for about 50 (38
detergent into the lower waste tank following dosage instructions and connect the
upper to the lower tank by fastening the two outside clips. Then open the valve by
pulling it out and operate the piston pump. Keep pumping until the bottom of the
waste tank is covered with water, then close the valve by pressing it in.
The toilet is now ready to be used. When using the toilet, open the valve again
and flush, then close the valve.
CAUTION : Do not overfill and do not put any detergents into the upper tank.
3. EMPTYING
The toilet must be emptied when the content of the waste tank comes up to about
3/4 cm from the slide valve. However, for hygienic reasons we recommend
emptying the toilet more often. Make sure the valve is fully closed and then
separate the two tanks. Then empty the waste tank in the designated place.
Before you put the toilet back together, please make sure the surfaces where the
two tanks meet and the slide valve are clean. Press the clean water tank into the
valve opening and press the side clips upwards.
The upper and the lower section are now properly connected to each other.
If the toilet is used
in low temperatures, e.g. for winter camping, add an antifreezer or ethylene glycol
to the water in the upper tank.
Regularly l ubricate rubber parts of the valve, the piston pump and the piston
with a silicon lubricant.
®
6
detergent fluids or powders by Fiamma sanitary line.
BP 30 ) uses. Pour sanitary