Grounding Instructions; Installation Instructions; For Your Safety - Silhouette DBC031D1BSSPR Guide D'utilisation Et Soins De Propriètaire

Masquer les pouces Voir aussi pour DBC031D1BSSPR:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Important Safety Information
READ AND FOLLOW ALL SAFETY INSTRUCTIONS

GROUNDING INSTRUCTIONS

This appliance is equipped with a cord having a grounding wire with a grounding plug. The plug must be plugged into an
outlet that is properly installed and grounded.
This appliance must be grounded. In the event of an electrical short circuit, grounding reduces the risk of electric shock
by providing an escape wire for the electric current.
WARNING - Improper use of the grounding plug can result in a risk of electric shock. Consult a qualifi ed electrician or
service agent if the grounding instructions are not completely understood, or if doubt exists as to whether the appliance is
properly grounded.
If the outlet is a standard 2-prong wall outlet, it is your personal responsibility and obligation to have it replaced with a
properly grounded 3-prong wall outlet.
For best operation, plug this appliance into its own electrical outlet to prevent fl ickering of lights, blowing of fuse or trip-
ping of circuit breaker
DO NOT USE AN EXTENSION CORD
Use an exclusive 115V wall outlet. Do not connect your appliance to extension cords or together with another appliance
in the same wall outlet. Do not splice the cord. Do not under any circumstances cut or remove the third (ground) prong
from the power cord. Do not use and adapter plug with this appliance.

Installation Instructions

FOR YOUR SAFETY

While performing installations described in this section, gloves and goggles or safety glasses should be worn. Two
people should be used when moving the beverage centre.
Remove interior and exterior packaging prior to installation.
Before connecting the appliance to a power source, let it stand upright for approximately 2 hours; this will reduce the
possibility of a malfunction in the cooling system from handling during transportation.
Place your beverage centre on a fl oor that is strong enough to support it when it is fully loaded. To level your bever-
age centre, adjust the front leveling leg at the bottom of the unit.
Locate the beverage centre away from direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct sun-
light and heat sources may increase electrical consumption. Extreme cold ambient temperatures may also cause the
unit to perform improperly.
Avoid locating the unit in moist areas.
Plug the beverage centre into an exclusive, properly installed-grounded wall outlet. Do not under any circumstanc-
es cut or remove the third (ground) prong from the power cord. Any questions concerning power and/or grounding
should be directed toward a certifi ed electrician or an authorized service centre.
Do not cover shelves with aluminum foil or any other material which may prevent air circulation.
In order for the cabinet to remain effi cient do not over load it.
Do not open the door unless necessary.
Should the beverage centre be stored without use for long periods, it is suggested, after careful cleaning, to leave the
door ajar. This will allow air to circulate inside the cabinet in order to avoid possible formations of condensation, mold
and odors.
SAVE THESE INSTRUCTIONS!
3

Publicité

Table des Matières
loading

Table des Matières