Operation - Bartscher 200061 Mode D'emploi

WARNING! Hazard via electrical current!
The device can cause injuries due to improper installation!
Before installation the local power grid specification should be compared with
that of the device (see type label).
Connect the device only in case of compliance! Take note of the security advice!
•
The electrical circuit of the socket must be secured to at least 16A. Only connect
the device to a wall outlet; do not use any extension cords or power strips.
•
Place the device so that the plug is easily accessible so as to quickly disconnect the
device if the need arises.

5.3 Operation

•
Prior to first use, wash the device with warm water and a mild cleaning agent.
Rinse with clean water and dry thoroughly.
•
Fill the reservoir with the desired amount of fresh water (up to the marking „MAX").
CAUTION!
To reduce the time needed for heating, fill the reservoir with warm water.
This will save time and energy!
WARNING! Danger of burns!
Fill with only the necessary amount of water! Too much water in the reservoir
may result in spilling and burns!
•
Place the lid on the reservoir using the lock, and turn the reservoir clockwise to close.
•
Connect the device to an appropriate outlet. The green control light will come on.
CAUTION!
It is important that water be in the device prior to turning it on. Do not will the
reservoir with other liquids which cannot be consumed, such as acids, alkalines,
oils, etc.!
- 21 -