Cable Connection - PROLUMIA LED ROCKDISC II Manuel D'utilisation

MOUNTING
1. Disassemble the diffuser.
2. Open the LED panel.
3. Pull the power cord through the gasket.
4. Fix the fixture on the surface with screws.
5. Connect the power cord on the terminal correctly. (Caution: Earth cable must be connected firmly.)
6. Close the LED panel.
7. Assemble the diffuser.
LED ROCKDISC II
LED ROCKDISC II (SEMI SHIELDED)
5

Cable connection

MAINS POWER SUPPLY
Remove in Master/Slave use
Without sensor
12
MAINS POWER SUPPLY
With sensor (switched phase not required)
www.prolumia.eu