Velleman RCQC3 Mode D'emploi page 6

1. Make sure your quadcopter is switched off. Slide the battery cover to open the battery
compartment.
2. Disconnect the battery wire and remove the battery from the quadcopter.
3. Connect the battery to the included USB cable and connect to a switched-on USB output. The LED
will switch on as soon as the battery is fully charged. Disconnect the battery from the USB output,
slide battery into the quadcopter, connect to the power input and close the battery compartment.
7.2 Installing the Landing Skids and Blade Protectors
1. Place the landing skids on the bottom of the quadcopter and fix with the screws.
2. Place one blade protector onto each arm and fix with the screw.
7.3 Synchronizing the Remote Control and Quadcopter
If you have not done so, install the charged
battery into your quadcopter. Also, install the
batteries in the remote control.
Push and hold the throttle stick completely
downwards.
V. 01 – 11/07/2016
RCQC3
Switch on your quadcopter by sliding the on-
off switch to the on position. Place the
quadcopter on a flat surface.
Switch on your remote control by sliding the
on-off switch to the on position. Synchronizing
has been completed when the remote control
beeps twice and the quadcopter's orientation
6
LEDs burn steadily.
©Velleman nv