Climadiff CLE18 Manuel D'utilisation page 34

Masquer les pouces Voir aussi pour CLE18:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

IMPORTANT:
If the power cable supplied is damaged, it must be replaced by the manufacturer, a service centre approved by
the brand or the retailer. In all events, it must be replaced by qualified personnel in order to avoid any risk of
injury.
I
F THESE CHECKS REVEAL NOTHING
Unplug the appliance before carrying out any maintenance or repair work.
12° PROBLEMS AND SOLUTIONS
You can solve many simple problems with your wine cellar yourself, thus avoiding having to contact your after-
sales department. Try the following suggestions.
PROBLEM
The cellar will not start.
The cellar does not cool sufficiently.
The compressor starts and stops frequently.
The light does not operate.
Vibration.
The cellar makes a lot of noise.
The door does not close correctly.
Error code E1 or E2
,
THEN CONTACT YOUR RETAILER
CAUTION!
The cellar is not plugged in.
The on/off button is in the off position.
The fuse in your electrical installation has blown.
Check the temperature selected.
The external temperature is beyond the cellar's operating
temperature.
The cellar is opened too often.
The door is not properly closed.
The door seal is not sealing correctly.
The external temperature is high.
A large quantity of bottles has been put into the cellar.
The cellar is opened frequently.
The door is not properly closed.
The cellar has not been correctly set.
The door seal is not sealing correctly.
The cellar is not plugged in.
The fuse in your electrical installation has blown.
The LED is not working.
The light switch is off.
Check and ensure that the cellar is level.
A noise resembling circulating water is produced by the
coolant gas and this is normal.
At the end of a cooling cycle, you can hear the noise of water
circulating.
Expansion and contraction of the internal walls may cause a
cracking sound.
The cellar is not level.
The cellar is not level.
The door seal is dirty or damaged.
The shelves are not positioned correctly.
A part of the contents is preventing the door from closing.
Sensor problem, contact your retailer's after sales department
'
A
-S
D
S
FTER
ALES
EPARTMENT
POSSIBLE CAUSES
.
34

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Cle51

Table des Matières