Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
DX-WGPNBC_WGPDTC_Combo.fm Page 2 Thursday, June 22, 2006 12:31 AM
2
Dynex DX-WGPNBC or
DX-WGPDTC Wireless LAN
Card
Contents
Introduction ..................................................................................... 2
Installing the software and hardware .............................................. 2
Configuring the wireless network .................................................... 3
Troubleshooting ............................................................................... 6
Legal notices .................................................................................... 7
Français ....................................................... 8
Español ...................................................... 15
Introduction
Thank you for purchasing a Dynex Wireless LAN 802.11g Enhanced
notebook or desktop card. This package contains:
• A Wireless LAN 802.11g Enhanced notebook or desktop card
• A printed user guide
• A CD containing the wireless network card utility and drivers and
this user guide
If anything is missing, contact Dynex at (800) 305-2204.
Installing the software and
hardware
Use the following procedures to set up your wireless network.
To install wireless networking on a Windows XP computer:
so.
Windows Explorer or My Computer to browse the CD and locate
the file named setup.exe, then double-click setup.exe to start
installing the software.
-OR-
Insert your notebook card into the appropriate slot in your
notebook. The Found New Hardware Wizard opens.
7 Click Install the software automatically (Recommended),
then click Next.
8 If a warning box opens, click Continue Anyway. Your computer
copies files to your hard drive.
9 Click Finish.
To install wireless networking on a Windows 98, Windows 2000, or
Windows ME computer:
Caution: Do not insert the notebook or desktop card until instructed to do
so.
1 Install the access point. For more information, see the access point
documentation.
2 Turn on your computer.
3 Insert the included CD in the optical drive.
4 If the installation program does not start automatically, use
Windows Explorer to browse the CD and locate the file named
setup.exe, then double-click setup.exe to start installing the
software.
5 Follow the on-screen instructions to install the software.
6 If you are installing a desktop card, turn off your computer, install
the card, then turn on your computer again. The Found New
Hardware Wizard opens.
-OR-
Insert your notebook card into the appropriate slot in your
notebook. The Found New Hardware Wizard opens.
7 Right-click on the My Computer desktop icon, click Properties,
then click Hardware Device Manager. Make sure that the card is
listed as one of the devices in your computer.
Contents
Publicité
Table des Matières
