Installing The Heater; Filling Fuel - Zibro Kamin Moonlighter Manuel D'utilisation

Convecteur à pétrole
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 1
MANUAL
A
A

INSTALLING THE HEATER

Carefully remove your Zibro Kamin heater from the box and check the
1
B
contents. In addition to the heater you also need to have:
the batteries
a manual fuel pump
these directions for use
Keep the box and the packaging materials for storage and/or transportation.
Remove the packaging material from the grill ¶ (Fig. A, B, C).
2
C
3
Fill the fuel tank as indicated in Section B.
Insert the batteries into their holder µ at the back of the heater (Fig. D).
4
Ensure that the positive and negative poles match the + and - marks indicated
on the battery housing.
D
The floor should be firm and completely level.
5
Your heater is now ready for use.
6
B

FILLING FUEL

Do not fill the fuel tank in the living room, but in a more suitable place (there can
E
always be some spillage). Follow the procedure below:
Make sure that the heater is switched off.
1
2
Insert the straight tube of the manual fuel siphon into the kerosene container.
Remove the fuel tank cap on the heater (Fig. E), and insert the siphon's flexible
hose into the fuel tank opening (Fig. F).
F
Lock the valve on top of the pump (turn clockwise).
3
Squeeze the pump a few times, until fuel starts flowing into the fuel tank.
4
As soon as this happens, there is no need to press any longer.
Stop filling by loosening the valve on top of the pump (turn anti-clock-wise),
5
once the gauge indicates that the tank is full.
Remove the siphon carefully, allowing the excess kerosene to drain from the
6
G
tube back into container. Replace the fuel tank cap and tighten it securely (Fig.
G). Be sure to wipe away any spilled kerosene from tank or other heater parts.
NOTE: Be especially careful to avoid overfilling the tank with very cold
kerosene; otherwise overflow might occur when the fuel warms up.
4
53

Publicité

Table des Matières
loading

Table des Matières