A
MANUAL
A
INSTALLING THE HEATER
1
Carefully remove your Zibro Kamin heater from the box and check the
contents. In addition to the heater you also need to have:
B
the batteries
a manual fuel pump
these directions for use
Keep the box and the packaging materials for storage and/or transportation.
Remove the packaging material from the grill ¶ (Fig. A, B, C).
2
C
3
Loosen the screw on the drip tray (Fig. D). Place the heater housing on the
base plate, insert the fuel tank and attach it with a screw to the base plate.
Tigten the screw.
4
Fill the fuel tank as indicated in Section B.
D
Insert the batteries into their holder µ at the back of the heater (Fig. E).
5
Ensure that the positive and negative poles match the + and - marks indicated
on the battery housing.
6
The floor should be firm and completely level.
E
7
Your heater is now ready for use.
B
FILLING FUEL
Do not fill the fuel tank in the living room, but in a more suitable place (there can
always be some spillage). Follow the procedure below:
F
1
Make sure that the heater is switched off.
2
Insert the straight tube of the manual fuel siphon into the paraffin container.
Remove the fuel tank cap ¹ on the heater (Fig. F), and insert the siphon's flexi-
ble hose into the fuel tank opening (Fig. G).
G
3
Lock the valve on top of the pump (turn clockwise).
4
Squeeze the pump a few times, until fuel starts flowing into the fuel tank.
As soon as this happens, there is no need to press any longer.
5
Stop filling by loosening the valve on top of the pump (turn anti-clock-wise),
once the gauge indicates that the tank is full (Fig. G).
6
Remove the siphon carefully, allowing the excess paraffin to drain from the
H
tube back into container. Replace the fuel tank cap and tighten it securely (Fig.
H). Be sure to wipe away any spilled paraffin from tank or other heater parts.
NOTE: Be especially careful to avoid overfilling the tank with very cold
paraffin; otherwise overflow might occur when the fuel warms up.
4
53