Bestron AWK780G Mode D'emploi page 24

OPERATION - General
The appliance is intended only for domestic use, not for professional use.
1. Jug
2. Water-level indicator
3. Lid
4. Lid release lever
5. Handle
6. On/off switch with pilot light
7. Spout with fine-mesh lime scale filter
8. Base
9. Power cord and plug
10. Blue LED lighting
OPERATION - Before use for the first time
Before using the kettle for the first time, you must first bring a full jug of water to the boil three times
and throw away the boiled water.
Tip: You can also use a vinegar solution the first time instead of water. Make sure that you do not fill the
jug completely. A vinegar solution boils over faster than water.
OPERATION - Boiling water
1. Turn the jug so that the spout faces away from you.
2. Open the lid.
3. Fill the jug with the required quantity of water (at least 0.5 litres, and a maximum of 1.7 litres). Never fill
the water boiler over the "max". Otherwise the hot water can spatter out of the base.
WARNING:
• Make sure that you do not spill any water.
4. Close the lid.
5. Insert the plug in the wall socket. Push down the On/off switch. The On/off pilot light and blue LED
lighting will illuminate.
6. The jug kettle is now switched on, and the water will now begin to heat. The jug kettle switches off
automatically a few seconds after the water has come to the boil. The On/off pilot light and LED lighting
will now extinguish.
7. Remove the jug by the handle, and pour the water out.
WARNING:
• Be carefull you do not contact the hot water. It can cause serious burning wounds.
3
7
MAX
1.7L
2
1.5L
1
1.0L
10
0.5L
MIN
8
24
EN
4
5
6
9