Bestron AWK1101W Mode D'emploi page 24

Masquer les pouces Voir aussi pour AWK1101W:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 9
OPERATION - General
The appliance is intended only for
domestic use, not for
professional use.
1. Jug
2. Water-level indicator
3. Lid
4. Button to open the lid
5. Handle
6. On/off switch with pilot light
7. Spout
8. Power cord and plug
OPERATION - Before first use
When using the jug kettle for the first time boil three jugs of water, and dispose of the boiled water.
Tip: You can use vinegar or special descaling agents for the first time.
OPERATION - Boiling water
1. Turn the jug so that the spout faces away from you.
2. Open the lid.
3. Fill the jug with the required quantity of water (at least 0.5 litres, and a maximum of 1.7 litres). Never fill
the water boiler over the "max". Otherwise the hot water can spatter out of the base.
4. Close the lid.
5. Insert the plug in the wall socket. Push down the On switch. The On/Off pilot light will illuminate.
6. The jug kettle is now switched on, and the water will now begin to heat. The jug
kettle switches off automatically a few seconds after the water has come to the boil. The On/Off pilot
light will now extinguish.
7. Remove the jug by the handle, and pour the water out.
8. When you wish to heat the water without it coming to the boil you can switch off the jug kettle at any
time you require by pushing the On/off switch.
9. Remove the plug from the wall socket when you have finished using the jug kettle.
WARNING:
Make sure that you do not spill any water.
Be carefull you do not contact the hot water. It can cause serious burning wounds.
OPERATION - Overheating safeguard
The jug kettle is fitted with an overheating safeguard. This will switch off the jug kettle if it is operated
without (sufficient) water. Allow the jug kettle to cool down for at least 10 minutes before using it again.
1
7
1
8
24
4
3
6
2
EN
5

Publicité

Table des Matières
loading

Table des Matières