Firmware Updates; Remote Control Code - Technics SU-R1A Mode D'emploi

Firmware updates

Occasionally, Panasonic may release updated firmware for
this unit that may add or improve the way a feature operates.
These updates are available free of charge.
≥ For the update information (new or improve features), refer
to the following website.
www.technics.com/support/firmware/
Preparation
≥ Connect this unit to the network. (
– Make sure that the network is connected to the Internet.
1
Press [SETUP].
2
Press [3, 4] repeatedly to select "F/W
Update" and then press [OK].
3
Press [3, 4] to select "Yes" and then press
[OK].
Do not disconnect the AC mains lead or press the unit
on/off button to the [
following messages is displayed.
"Linking" or "Updating"
≥ During the update process, no other operations can be
performed.
≥ When the update has finished successfully, "Success" is
displayed.
4
After "Success" is displayed, disconnect the
AC mains lead and then reconnect it after
3 minutes.
≥ If there are no updates, "No Need" is displayed after step 3.
≥ Downloading will require several minutes. It may take longer or
may not work properly depending on the connection environment.
∫ Checking the firmware version and the
model number
1 Press [SETUP].
2 Press [3, 4] repeatedly to select "F/W Version" and
then press [OK].
≥ Press [OK] to exit.
22
(22)
14)
] position while one of the

Remote control code

When other equipment responds to the supplied remote
control, change the remote control code.
≥ The factory default is "Mode 1".
Point the remote control at this unit, and press
and hold [OK] and the numeric button for at least
4 seconds.
≥ When the remote control code is changed, the new code
will appear on the display for a few seconds.
[OK] + [1] Set the code to "Mode 1"
[OK] + [2] Set the code to "Mode 2"
Changing the character
encoding
You can change the character encoding of track names,
artist names and other information when they are not
displayed as they should be.
≥ The factory default is "Type 1( 日本 )".
1
Press [SETUP].
2
Press [3, 4] repeatedly to select "E Asian
Character" and then press [OK].
3
Press [3, 4] to select
"Type 1( 日本 )"/"Type 2( 简体字 )" and then
press [OK].
Priority is given to Japanese.
Type 1( 日本 )
Priority is given to Chinese
Type 2( 简体字 )
(Simplified).