Remote Control - Domo DO8124 Mode D'emploi

ASSEMBLY
1. Turn the fan upside down and put it on a soft surface, so
that the control panel can not get damaged.
2. Click the 2 parts of the base together.
3. Lead the cord through the middle opening at the top of
the base.
4. Place the base on the bottom of the fan, so that the screw
holes in the bottom of the fan and in the base are aligned.
Make sure that the part of the base with the cord guides is
situated at the back of the fan.
5. Fasten the base on the fan using the 4 long screws.
6. Leid the cord through the cord guides in the base.
7. Turn the fan upside down again. The appliance is now
ready for use.

Remote control

The battery CR2025 is included. Remove the plastic safety clip from the battery compartment
at the back of the remote control before use.
USE
You can control the fan with the buttons on the control panel as well as with the buttons on
the remote control.
Place the fan on a flat, stable surface. Plug it in.
POWER
Switch on the fan by pressing the POWER button. Switch off the fan by pressing the POWER
button for a second time.
SPEED
Select the desired air speed by pressing the SPEED button. The selected speed will be
indicated on the LED display:
· I: low speed
· II: medium speed
· III: high speed
MODE
There are 3 different modes, which you can select by pressing the MODE button. The selected
mode will be indicated on the LED display:
24
DO8124