Pioneer AVH-P5100DVD Manuel D'installation page 7

Wired remote input
Hard-wired remote control adaptor
can be connected (sold separately).
IP-BUS input IP-BUS cable
(Blue)
Yellow/black
If you use an equipment with Mute function, wire this lead to the Audio Mute lead on
that piece of equipment. If not, keep the Audio Mute lead free of any connections.
Connection method
1. Clamp the lead.
Note:
• The position of the parking brake switch depends on the vehicle model. For details,
consult the vehicle Owner's Manual or dealer.
Light green
Used to detect the ON/OFF status of the parking brake. This
lead must be connected to the power supply side of the parking
brake switch.
Blue/white
Connect to system control terminal of the power
amp or auto-antenna relay control terminal
(max. 300 mA 12 V DC).
With a 2 speaker system, do not connect
anything to the speaker leads that are not
connected to speakers.
When you connect the separately sold multi-
channel processor (e.g., DEQ-P8000) to this
unit, do not connect anything to the speaker
leads and system remote control
(blue/white).
Interface cable (e.g., CD-IU205V)
(sold separately)
80 cm (2 ft. 7 in.)
Multi-CD player
(sold separately)
Power supply side
Ground side
Note:
• Change the initial setting of this unit (refer to the
Operation Manual). The subwoofer output of this unit
is monaural.
Dock connector
Connect to separately sold iPod.
80 cm (2 ft. 7 in.)
Tuner box (supplied)
Antenna cable
(supplied)
2. Clamp firmly with
needle-nosed pliers.
Parking brake
switch
6