Publicité
(2)
Roofing Nail
Clou pour toiture
Clavo de techar
Wall Flange
Bride du mur
Reborde de la pared
(1)
Wall Tab
Languette du mur
Lengüeta de la pared
Receptor Slot
Rainure du receveur
Ranura del receptor
Pre-Fit the Wall Surrounds
NOTE: For receptors without wall surrounds, proceed to the "Install the Finished
Walls" section.
IMPORTANT! Install the back wall first.
NOTE: The appearance of your receptor and wall surrounds may differ from the
illustration. The installation steps still apply.
Ensure the bath surface is free of debris. This will minimize the gaps between the
wall surrounds and the bath surface.
Position the back wall with the tabs engaged in the receptor slots (1).
Temporarily install a roofing nail or equivalent over the top of the back wall
flange and into the center of a stud (2). Do not drive the nail in so far that it will
interfere with the end wall installation.
Position the end walls with the pins engaged in the wall slots on the back wall (3).
Ensure the wall tabs are still engaged into the receptor slots. Do not secure the
end walls to the stud framing at this time.
Verify that the back wall is flush against the receptor. If adjustment is needed,
remove the roofing nail from the back wall and reposition it. Reinstall the roofing
nail.
Verify that the end walls are flush against the edge of the receptor. If adjustment is
needed, push or pull the end walls to reposition them.
Verify that all walls are properly aligned with the studs at the top and vertical
wall flanges. If needed, add shims to bring the studs into contact with the walls.
Sterling
(3)
Wall Slot
Rainure du mur
Ranura de la
pared
21
Pin
Tige
Clavija
1064904-2-A
Publicité
