Bosch AGS 7,2 LI Notice Originale page 24

24 | English
Assembly
For Your Safety
Warning! Switch off before adjusting or
cleaning. The blades continue to move for a
few seconds after the garden product is
switched off.
Caution! Do not touch the moving blades.
Battery Charging (see figure A)
Do not use other battery chargers. The sup-
plied battery charger is designed for the Lith-
ium-Ion battery in your garden product.
Observe the mains voltage! The voltage of
the power supply must correspond with the
data given on the nameplate of the battery
charger. Battery chargers marked with 230 V
can also be operated with 220 V.
The voltage range of the charger is
100–240 V. Ensure that the plug matchs the
outlet.
Note: The battery is supplied partially charged.
To ensure full capacity of the battery, complete-
ly charge the battery in the battery charger be-
fore using your power tool for the first time.
The lithium ion battery can be charged at any
time without reducing its service life. Interrupt-
ing the charging procedure does not damage the
battery.
The "Electronic Cell Protection (ECP)" protects
the lithium ion battery against deep discharging.
When the battery is run down or discharged, the
garden product is shut off by means of a protec-
tive circuit: The blade no longer moves.
Do not continue to press the
WARNING
On/Off switch after the garden
product has been automatically switched off.
The battery can be damaged.
Plug the mains plug of the battery charger into a
socket outlet and the charger plug 6 into the
socket 15 on the rear side of the handle, in one
way only.
The charging procedure starts as soon as the
charger plug 6 of the battery charger is inserted
into the socket 15.
F 016 L70 608 | (27.1.10)
The battery charge-control indicator 2 indicates
the charging progress. During the charging proc-
ess, the indicator flashes green. When the bat-
tery charge-control indicator 2 lights up green
continuously, the battery is fully charged.
During the charging procedure, the handle of
the garden product warms up. This is normal.
Disconnect the battery charger from the mains
supply when not using it for longer periods.
The garden product cannot be used during the
charge procedure; it is not defective when inop-
erative during the charging procedure.
Protect the battery charger against mois-
ture!
Pole cart (accessory or supplied with
"Grass Shear & Pole Cart")
The pole cart is designed only for use with
the grass shear at ground level.
Do not use the pole cart with the shrub
shear or above ground level.
Removing Pole Cart (see figure B)
Unplug the handle connector 12.
To release the garden product from wheel
cart 14, pull the garden product in the direc-
tion shown.
Fitting Pole Cart (grass shear only)
Align the grooves on the garden product with
fixing on the wheel cart 14.
Plug in the handle connector 12.
Adjusting Handle Length (see figure C)
Loosen the adjustment collar 11.
Pull the telescopic pipe 10 out to increase
the height, or push it in to decrease the
height.
Re-tighten adjustment collar 11.
Adjusting for Edging Mode (see figure D)
Turn the garden product 90 °, in either direction
to position the garden product in the vertical
edging mode.
Bosch Power Tools