GE AEH05 Manuel D'utilisation Et Instructions D'installation page 10

WINDOW REQUIREMENTS
1
• These instructions are for a standard double-
hung window. You will need to modify them
for other types of windows.
• The air conditioner can be installed without
the accordion panels if needed to fit in a
narrow window. See the window opening
dimensions.
• All supporting parts must be secured
to firm wood, masonry or metal.
• The electrical outlet must be within reach of
the power cord.
• Follow the dimensions in the table and
illustration for your model.
Models
AEH05, AES05 13" min.
AEH06, AEH08 13 5/8" min.
(With accordion panels)
STORM WINDOW REQUIREMENTS
2
A storm window frame will not allow the air
conditioner to tilt toward the outside, and will
keep it from draining properly.
To adjust for this, attach a piece of wood to
the sill.
WOOD PIECES
WIDTH: 2"
LENGTH: Long enough to fit inside the
window frame.
THICKNESS: To determine the thickness, place
a piece of wood on the sill to make it 1/2"
higher than the top of the storm window
frame or the vinyl frame.
Attach securely with nails or screws provided
by the installer.
1/2" higher
than storm
window
frame
Storm window
frame
Installation Instructions
A B
24 1/2"–38 1/8"
24 1/2"–38 1/8"
A
B
1/2" higher
than vinyl frame
(on some windows)
Wood
Sill
Vinyl frame
ATTACH THE TOP MOUNTING
3
RAIL SEAL STRIP
Remove the backing from the top mounting
rail seal strip and attach the seal strip to the
bottom of the top mounting rail, along the
front edge.
FRONT VIEW
4 PREPARE THE AIR CONDITIONER
Install the top mounting rail with 3 Type B
A
screws from the outside of the case.
Top mounting rail
Bottom mounting rail
Slide the left and right accordion panels
B
into the top and bottom mounting rails.
Top left
10
Top mounting rail
Remove
backing
from seal
strip
Top mounting rail
Seal strip
Top right