GE AEH18 Série Manuel D'utilisation Et Instructions D'installation page 12

Window Installation Instructions
PREPARE THE WINDOW
5
Cut the window sash seal to the proper
length. Peel off the backing and attach the
seal to the underside of the window sash.
PREPARE THE CASE
6
Install the top mounting rail with 4 type B
A
screws from the inside of the case.
Top mounting rail
Insert the frames for the accordion panels
B
into the top mounting rail and the bottom
frame guides. Attach the accordion panels
to the side of the case using 3 type A screws
on each side.
Note: When attaching the accordion panels,
make sure to only screw the inner panels
to the case sides.
Top mounting rail
Type A
screws
Bottom mounting rail
7 INSTALL THE CASE
IN THE WINDOW
Carefully slide the case into the window and
A
center the case. Lower the window behind
the top mounting rail. Pull the bottom of the
case forward so that the bottom mounting
rail is tight against the back of the window
sill. Mount the case to the window sill using
4 type E screws. Drill pilot holes, if necessary.
Sill
Make sure the bolts and nuts are all of the
B
way in both the left and right V-supports.
Position the V-supports on the case bottom
C
so that they will be near the outside wall.
Attach a V-support to each side of the bottom
of the case using type C screws,
3 on each side.
BACK
12
4 type E screws
Bolt and nut
V-support