Publicité
Les langues disponibles
Les langues disponibles
1. SAFETY INSTRUCTIONS
Please read carefully the instruction, which includes important information about the installation,
Please keep this User Guide for future consultation. If you sell the unit to another user, be sure that they also receive this instruction
manual.
Important:
Damages caused by the disregard of this user manual are not subject to warranty. The dealer will not accept liability for
any resulting defects or problems.
Unpack and check carefully that there is no transportation damage before using the unit.
The unit is for indoor use only. Use only in a dry location.
DO install and operate by qualified operator.
DO NOT allow children to operate the fixture.
Use safety chain when fixing the unit. Handle the unit by carrying its base instead of head only.
The unit must be installed in a location with adequate ventilation, at least 50cm from adjacent surfaces.
Be sure that no ventilation slots are blocked, otherwise the unit will be overheated.
Before operating, ensure that the voltage and frequency of power supply match the power requirements of the unit.
It's important to ground the yellow/green conductor to earth in order to avoid electric shock.
Maximum ambient temperature Ta: 40℃. DO NOT operate it when the temperature is higher.
DO NOT connect the device to any dimmer pack.
During initial start-up some smoke or smell may arise. This is a normal process and does not necessarily mean that the device is
defective, and it will decrease gradually within 15 minutes.
Make sure there are no flammable materials close to the unit while operating to avoid fire hazard.
Examine the power wires carefully, replace them immediately if there is any damage.
Avoid any inflammable liquids, water or metal objects entering the unit. Once it happens, cut off the mains power immediately.
DO NOT operate in dirty or dusty environment, do clean fixtures regularly.
DO NOT touch any wire during operation as there might be a hazard of electric shock.
Avoid power wires together twist other cables.
Disconnect mains power before fuse/lamp replacement or servicing.
In the event of serious operating problem, stop using the unit immediately.
Never turn on and off the unit time after time.
DO NOT open the unit as there are no user serviceable parts inside.
Never try to repair the unit by yourself. Repairs carried out by unskilled people can lead to damage or malfunction. Please contact
the nearest authorized technical assistance center if needed.
Disconnect the mains power if the fixture is has not been used for a long time.
DO use the original packing materials before transporting it again.
Caution：
To prevent or reduce the risk of electrical shock or fire, do not expose the unit to rain or moisture.
DO NOT look directly at the light while the bulb is on.
Never touch bulb with bare fingers, as it is very hot after using.
DO NOT start on the unit without bulb enclosure or when housing is damaged.
Installation :
The unit should be mounted by its screw holes on the bracket. Always ensure that the unit is firmly fixed to avoid vibration and slipping
while operating. The structure to which you are attaching the unit should be able to support 10 times the weight of the unit. Also always use
a safety cable that can hold 12 times the weight of the unit when installing the fixture.
The equipment must be fixed by professionals.
Accessories :
The accessories below were packed with product,
please check if they are once open the package.
Power cable: 1PC
User Manual: 1 PC
usage and maintenance.
Publicité
