Publicité
Les langues disponibles
Les langues disponibles
LEVELING UNIT
This hotplate is supplied with 4 feet or floor stand legs
which must be screwed into the body. Unit must be
level. Level unit by adjusting the (4) feet which have an
adjustment of 1-3/4" for accurate and perfect line-up with
other units.
COUNTER TOP MODEL
ON OPTIONAL EQUIPMENT STAND
Caster Kits: Casters can be used with floor stand models or optional equipment stand. For installation, carefully mark
and cut off from the bottom of each leg using a straight cutting saw and de-burr the inside tube wall prior to installing the
caster. Cut leg should measure 19" tube length, not overall length. On SFC models only, use kit number ES-UM36SFC.
Casters add about 6-1/4" of height to the unit. Be sure to use approved strain relief means for protecting gas line
connection. If an appliance is equipped with casters and is gas connected with a quick connect coupling, all personnel
must be aware that there is a restraint on the appliance and if disconnected for service or cleaning it must be reconnected
as originally installed prior to use.
CAUTION
DO NOT INSTALL WITHOUT ATTACHING
FEET OR SUPPLIED STAND LEGS AND
SHELF - DO NOT REMOVE FEET.
SCREW LEGS INTO
MOUNTING NUTS ON BOTTOM
STIFFENING SUPPORTS FOR
808 MODELS ONLY
FLOOR STAND SHELF
FLOOR STAND MODEL
(Floor stand not available for 802 models)
5
IL2506
Publicité
