Danby DDR020BIWDB Manuel Du Propriétaire page 4

OPERATING INSTRUCTIONS
OPERATION
• Place the dehumidifi er on a smooth, level fl oor
that is strong enough to support the appliance
with a full bucket of water.
• Do not place the dehumidifi er on carpeting as
this can block air fl ow around the appliance.
• Do not force casters to move over carpeting as
the appliance can become unbalanced and spill
water.
• To maintain effi ciency, operate the appliance
in an enclosed area. Keep nearby doors and
windows closed.
• Maintain a minimum clearance of 20 cm (8
inches) on the sides and back of the appliance
and 40 cm (16 inches) on the top and front of
the appliance to allow for proper air circulation.
• The recommended ambient operating
temperature is between 5°C (41°F) and 32°C
(90°F).
• Any time the appliance is placed on its back or
side, it must be allowed to stand upright for 6
hours before plugging in to avoid damage to
internal components.
• The default humidity setting is 40% and high fan
speed. Depending on humidity conditions the
dehumidifi er may not start automatically under
the default setting. This means the humidity in
the surrounding air is less than 40%. Press the
down button to lower the set humidity until the
set humidity is lower than the ambient humidity.
• For optimal performance, ensure that the
humidity setting is 10% lower than the ambient
humidity. It is normal for the ambient humidity to
vary up to 5% above or below the set humidity.
• It is recommended in normal conditions to set
the humidity between 40-45%.
• It is normal for the dehumidifi er to exhaust warm
air from the top.
FEATURES
Front
1. Control Panel
2. Handles (both sides)
3. Air Outlet
4. Air Intake
5. Air Filter
6. Water Bucket
1
Back
1. Continuous Drain Outlet
2. Power Cord Storage Band
3. Power Cord
1
3
3
2
4
3
5
6
2