Table des Matières
Publicité
OPERATING INSTRUCTIONS
Turn the electrical supply on at the fused spur
Your cooker hood is controlled by electronic pushbuttons and a remote controller
The cooker hood motor should be switched on 5 to 10 minutes before starting to cook (without drafts, in
order to facilitate stable air flow during cooking) and switched off 5 to 10 minutes after the burners are
extinguished.
Pushbutton Functions
Motor RUN ON TIMER
(OFF after 10 minutes to clear fumes)
Motor ON – SPEED 4
(Intensive Mode)
Motor ON - SPEED 3
(Maximum Speed for Normal Use)
Motor ON - SPEED 2
Motor ON - SPEED 1
Motor OFF
Lights ON/OFF
The extractor controller automatically switches off the appliance if there has been no operator
action for 4 hours.
After 30 hours accumulated running, GREASE FILTER CLEANING will be signalled by all 6 indicators
flashing. Reset by pressing RUN ON TIMER Push-button.
Note: Should the extractor fail to respond to commands from the remote-controller, please check that
the power is 'ON' and the internal red appliance reset switch is in the 'ON' position (factory default).
The reset switch is a latching red push-switch located behind the grease filter(s).
Press the switch fully to change between 'ON' (switch in) and 'OFF' (switch out) modes.
After switching the red switch or mains power from 'OFF' to 'ON' it is advisable to register the remote
controller with the appliance.
To register the remote with the appliance: Press the light switch on the remote controller several
times during the start sequence (which lasts for 15 seconds after switching on the power). If the mains
power and reset switch are both in the 'ON' position, the remote control should register and the lights
will operate.
Should your remote-controller stop working, you should install a new battery and/or re-register the
remote controller (as described above) before seeking further assistance.
If you experience interference problems or the controller appears to be faulty, then a diferent radio
transmission code or factory reset transmission code may be required.
Use and Care
.
Remote Control Functions
Function Indicator
LEDs
Lights
ON/OFF
Motor ON/
Speed 1/OFF
31
.
INCREASE SPEED
Speeds 2, 3, 4
RUN ON TIMER
(MOTOR OFF after 10
minutes to clear fumes)
DECREASE SPEED
Publicité
Table des Matières
