Mobile Phone Holder; Battery And Charger; Maintenance - SoFlow SO3 Mode D'emploi Original

3.3 Mobile phone holder

Your SO3 comes with a mobile phone holder which can be easily attached or detached. Simply wrap the strap around the handlebar, pull it through the buckle and make sure it is firmly secured.
You can pull around the mount to check if your mobile phone is firmly held in place. The stretchable silicon bands can hold all smartphones with a screen size from 4 to 6.2 inches.
WARNING!

3.4 Battery and charger

The range of the battery may differ from the specifications depending on the temperature, the condition of the track, the incline and the weight of the driver.
Charging the battery
Make sure that the charging connector and the charger are dry and that the SO3 is switched off. Connect the charger cable to the scooter's charging connector and plug it into an electrical outlet.
The charging light on the charger should glow red. When the charging light changes from red to green, the battery is fully charged. Disconnect the charger from the power source and the scooter.
The e-scooter should only be charged with the original charger. Ensure that the voltage supply is correct. Do not use the charger if the charger or power cable are damaged. Please contact the
service department. For optimum battery life, charge and store the e-scooter in a dry and clean environment, preferably room temperature. The charging time of the scooter is approximately 4-
6 hours. There will be negative effects on the battery life if the charger remains permanently connected to the scooter and the power source.
Battery handling
Do not cover the scooter or the charger during charging. Lithium batteries have different freezing points depending on their charge level. If a battery cell freezes, it is irreparably destroyed and
the entire battery must be replaced. As with conventional batteries, a lithium battery loses up to 40% of its capacity starting from approximately 0°C. At approximately 20°C and 100% charge, a
lithium battery loses approximately 30% of its capacity per month (poor storage conditions).
Correct handling of the battery
Never remove the battery from the scooter. Charge the battery for at least 1 hour every 2 months (even when not in use). Never heat the battery or expose it to open fire. Never dispose of the
battery cells together with general waste. Never bring battery contacts into contact with moisture. The ideal operating temperature of the battery is between 10°C and 30°C. Above as well as
below this temperature, the power output deteriorates, resulting in a reduced range and power output.
The life and performance of a battery depends on its age, care and how often it has been used. Compared to other battery models, lithium ion batteries have very low self-discharge and a very
low memory effect, but they need to be charged periodically. Even if you do not use your scooter, the battery must be charged for at least 1 hour every 2 months, otherwise it will lose capacity.
Regular charging will prevent the battery from total discharge. Please note that an excessively discharged battery is irreparably damaged and must be replaced for a fee, hence the battery should
never be completely discharged during operation.
WARNING!

3.5 Maintenance

Do not try to charge the SO3 when the battery is already full. This could diminish the battery's capacity in the long run.
Before every ride, check all screws of the device, especially those of the handle and frontbar, the mudguard and the front and rear wheel. Tighten all screws firmly to ensure safety when using
your SO3.
copyright by www.soflow.com 14