Installing the Microphone Unit (KDC-X696 only)
Check the installation position of the
1
microphone H.
Remove oil and other dirt from the
2
installation surface.
Install the microphone.
3
Wire the microphone cable up to the
4
hands-free box with it secured at several
positions using tape or the like.
Install the microphone as far away as
■ ■
possible from the cell-phone.
Troubleshooting
Symptom
Sound cannot be heard.
"PROTECT" appears and no operations can
be done.
The unit does not work at all.
Radio reception is poor. / Static noise while
listening to the radio.
"IN" flashes.
CD-R/CD-RW cannot be played back and
tracks cannot be skipped.
Disc sound is sometimes interrupted.
"NA FILE" appears.
"NO DISC" appears.
"TOC ERROR" appears.
"ERROR 99" appears.
30
English
Peel off the release
coated paper of
double-face adhesive
tape to secure the
microphone on the
place shown above.
Adjust the volume to the optimum level. / Check the cords and connections.
Check to be sure the terminals of the speaker leads are covered with insulating tape
properly, then reset the unit. If "PROTECT" does not disappear, consult your nearest
service center.
Reset the unit.
Connect the antenna firmly. / Pull the antenna out all the way.
The CD player is not operating properly. Reinsert the disc properly. If the condition did
not improve, turn off the unit and consult your nearest service center.
Insert a finalized CD-R/CD-RW (finalize with the component which you used for
recording).
Stop playback while driving on rough roads. / Change the disc. / Check the cords and
connections.
The unit is playing an unsupported audio file.
Insert a playable disc into the loading slot.
The CD is quite dirty. / The CD is upside-down. / The CD is scratched a lot. Try another
disc instead.
The unit is malfunctioning for some reason. Press the reset button on the unit. If the
"ERROR 99" code does not disappear, consult your nearest service center.
H
Fix a cable with a commercial
item of tape.
Turn the microphone
toward the driver.
Remedy/Cause