Operation Manual For Ir Wireless Remote Controller - Mitsubishi Electric Mr.SLIM PKA-A KA6 Série Manuel D'utilisation

9. Operation Manual for IR wireless remote controller

9.1 Parts Names
Remote controller display
* For explanation purposes, all of the items
that appear in the display are shown.
* All items are displayed when the Reset
button is pressed.
Set Temperature buttons
Fan Speed button (Changes fan speed)
Air ow button (Changes up/down air ow direction)
Mode button (Changes operation mode)
Note:
When using the IR wireless remote controller, point it towards the receiver on the indoor unit.
If the IR wireless remote controller is operated within approximately 2 minutes after power is
supplied to the indoor unit, the indoor unit may beep twice as the unit is performing the initial
automatic check.
The indoor unit beeps to confirm that the signal transmitted from the IR wireless remote
controller has been received. Signals can be received up to approximately 7 meters in
a direct line from the indoor unit in an area 45° to the left and right of the unit. However,
illumination such as fluorescent lights and strong light can affect the ability of the indoor unit
to receive signals.
If the operation lamp near the receiver on the indoor unit is blinking, the unit needs to be
inspected. Consult your dealer for service.
Handle the IR wireless remote controller carefully! Do not drop the IR wireless remote
controller or subject it to strong shocks. In addition, do not get the IR wireless remote
controller wet or leave it in a location with high humidity.
To avoid misplacing the IR wireless remote controller, install the holder included with the
IR wireless remote controller on a wall and be sure to always place the IR wireless remote
controller in the holder after use.
CHECK
COOL
MODEL
DRY
SELECT
AUTO
FAN
FAN
HEAT
NOT AVAILABLE
ON/OFF button
Check button
Test Run button
Transmission area
Transmission indicator
TEST
RUN °F
°C
Timer indicator
STOP AMPM
SWING
START AMPM
Operation areas
Timer Off button
Timer On button
Hour button
Minute button
Set Time button (Sets the time)
Louver button (Changes left/right air ow direction)
Reset button
Battery installation/replacement
1. Remove the top cover, insert 2 AAA batteries,
and then install the top cover.
Top cover
2. Press the Reset button.
1
2
3
2 AAA batteries
Insert the negative (–)
end of each battery first.
Install the batteries in
the correct directions
(+, –)!
Press the Reset
button with an object
that has a narrow end.
9