Polar GM498 Mode D'emploi page 4

UK
Installation
Note: If the unit has not been
stored or moved in an upright
position, let it stand upright for
approximately 12 hours before
operation. If in doubt allow to
stand.
1. Remove the appliance from the packaging.
Make sure that all protective plastic film and
coatings are thoroughly removed from all
surfaces.
2. To optimize performance and longevity, ensure
a minimum clearance of 2.5cm is maintained
between the unit and walls and other objects,
with a minimum 5cm clearance on the top.
NEVER LOCATE NEXT TO A HEAT SOURCE.
Note: Before using the appliance
for the first time, clean the
shelves and interior with soapy
water.
3. Set the brakes on the castors to keep the
appliance in position.
Operation
Control Panel - GM498
Temperature Display
4
GM498-GM499_ML_A5_v1_20211109.indb 4 GM498-GM499_ML_A5_v1_20211109.indb 4
RUN indicator
Thermostat
Battery compartment
Control Panel - GM499
Battery compartment
Temperature Display
Storing Food
To get the best results from your POLAR appliance,
follow these instructions:
• Only store foodstuffs in the appliance when it
has reached the correct operating temperature.
• Do not place uncovered hot food or liquid
inside the appliance.
• Wrap or cover food where possible.
• Do not obstruct the fans inside the appliance.
• Avoid opening the doors for prolonged periods
of time.
• Condensation will form in refrigeration with
frequent opening of the doors and on hot
humid days, please ensure condensation is
allowed to drain properly or is wiped dry.
Turn On
1. Close the lid of the appliance.
2. Turn on the appliance.
3. Set the thermostat to the desired temperature.
Defrost
POLAR recommend defrosting the appliance when
any frost build up inside the freezer reaches 5mm
thick. To do this switch the freezer off at the power
supply.
Cleaning, Care &
Maintenance
Switch off and disconnect from the power
•
supply before cleaning.
• Clean the interior of the appliance as often as
possible.
• Do not use abrasive cleaning agents. These
can leave harmful residues.
• Clean the door seal with warm water only.
• Always wipe dry after cleaning.
• Do not allow water used in cleaning to run
through the drain hole into the evaporation
pan.
RUN indicator
Thermostat
2021/11/9 11:12 2021/11/9 11:12