Bestron DCF52LSR Mode D'emploi page 36

MOUNTING - Mounting the fan blades to the motor housing
1. Remove the two screws from the covering plate on the top of the motor housing (see figure F).
Use a magnetic screwdriver for the following steps! Use a magnetic screwdriver for the following steps!
2. Insert the blade through the slots around the motor. Align the blade with the three holes, and secure the
three fan blade screws (see figure 1-7) through the opening exposed when covering plate was removed.
If the holes do not align, the blade is upside down. The blade is designed to fit snugly, the screws should
be vertical with the blade (G).
3. Replace the covering plate on top of the motor housing by reversing step 1.
4. Repeat for the other four fan blades, tighten al blade screws evenly and securely to ensure quiet, wobble
free opperation of the fan.
F
The fan blades are now properly mounted.
G
36
EN