Lupus Electronics LUPUSNET LE965 Guide Rapide page 10

1. Right-click on the desktop. Select "Properties" and Change "Color
Quality" to Highest (32bit).
B.
Connect a power adapter and IP Camera to PC or local network
1. I/O Control Instruction
I/O terminal connector – used in application, for e.g., motion detection, event
triggering, alarm notifications. It provides the interface to:
1 Digital Input (GND+Alarm) – An alarm input for connecting devices that
can toggle between an open and closed circuit, for example: PIRs,
door/window contacts, glass break detectors, etc. When a signal is received the
state changes and the input becomes active.
1 Relay output (COM +N.O.) / (COM+N.C.) – An output to Relay switch, for
example: LEDs, Sirens, etc
2. Digital Input
Alarm Input
1. GND (Ground) : Initial state is LOW
2. Alarm : Max. 50mA, DC 3.3V
A. Monitor Setting
Hardware Installation
10/24