Publicité
Les langues disponibles
Les langues disponibles
Overview
1
Operating Handle
2
Clamping Handle
3
Travel Block with Blade Holder
4
Locking Lever
5
Travel Spindle
6
Outside-pipe Bearing
Operating instructions
Using a suitable pen, mark the fitting edge on the pipe.
Unlock the locking lever (4) and position the travel block (3) to the back.
Push the peeling tool all the way to the head rail (8) onto the pipe and secure it to the pipe by tightening the
clamping handle (2) loosely.
Push down the quick-release (11) and position the travel block (3) where peeling should start.
Unlock the locking lever (4) and push the travel block/blade holder (3) down on the pipe until the blade
height adjuster (10) shows a blade position of approx. 3 - 4mm.
Lock the locking lever (4) and, using the operating handle (1), move the peeling tool swiftly around the pipe
in a circular motion in the direction indicated by the arrow (clockwise), until it turns freely.
While peeling the pipe end, push the peeling tool down on the pipe to prevent it from tilting out of the pipe's
axis.
Unlock the locking lever (4), put the travel block (3) in its position at the back, and pull the peeling tool from
the pipe after loosening the clamping handle (2).
Care and maintenance
Replace damaged parts immediately. When servicing the product, always use genuine spare parts
The obligatory service and maintenance work has to be performed respecting the proper intervals. It is
recommended that the product be serviced at least once a year.
Store in a dry location. Protect from strong vibrations and shocks. When using the product, handle with
care.
Maintenance
Keep travel spindle and bearings/shafts clean.
Blade can be used on all 4 edges. Bearings do not require maintenance.
Storage
When the peeling/chamfering tool is not in use, store it in its corresponding transport box.
Disposal
Components of the unit are recyclable material and should be put to recycling. For this purpose registered
and certified recycling companies are available. For an environmental friendly disposal of the non-recyclable
parts (e.g. electronic waste) please contact your local waste disposal authority.
7
Inside-pipe Bearing
8
Head Rail (Pipe Stopper)
9
Threaded Safery Cap
10 Blade Height Adjuster
11 Quick-release Button (behind locking lever)
12 Multiple Blade (four sharpened edges bit)
Publicité
