Key Beeps; Resetting Data In The Memory - ADVANSEA WIND S400 Manuel Utilisateur

To activate the simulation mode:
menu
Press for 2 seconds, then again on
page « SIM » is displayed, then press
to switch "OFF".
Press to exit setup mode or automatic timeout after 10
seconds.

2.4.6. Key beeps

The key beeps can be activated or deactivated.
To activate or deactivate the key beeps:
menu
Press for 2 seconds, then again on
"bIP" is displayed, then press
switch "OFF".
Press to exit setup mode, or automatic timeout after 10
seconds.

2.4.7. Resetting data in the memory

At any time, the memory of the display can be returned to factory settings. To do
so, a memory reset command is accessible in the menu.
The following parameters are restored in the memory:
Anemometer unit:
Wind indicator and anemometer filtering:
Wind calibration coefficient:
Gauge calibration coefficient:
Wind and battery alarms:
Wind indicator angle (180/360):
Simulation mode:
Backlighting level:
To reset the memory:
menu
Press for 2 seconds, then again on
page "RSt" is displayed, then press
the reset.
Press to exit setup mode, or automatic timeout after 10
seconds.
menu
menu
to switch "ON" and
Installation and Operation Manual S400 series
until the simulation
to switch "ON" and
until the beep page
Knots
10 seconds
slope at 1
Offset to 0
deactivated, threshold at 0
0/180° port, starboard
deactivated
0 (OFF)
menu
until the reset
or to activate
to
13