Télécharger Imprimer la page

DeWalt DCMW290 Guide D'utilisation page 11

Tondeuse sans fil

Publicité

Les langues disponibles

Les langues disponibles

2. Lift the rear door cover 
 11 
insert 
 22 
fully into the mower as shown in Fig. G.
3. Ensure the rear door cover is down before turning
mower on.
Fig. G
Rear Discharge

DANGER: Remove safety key and battery pack before
removing collection bag, and mulching insert.
1. To operate mower in rear discharge mode remove both
the bag and the mulching insert.
2. Be sure rear door cover is down for rear discharge.
nOTE: The rear door is shaped in such a way that the
opening (at the bottom) cannot be completely closed off.
OPERATION

DANGER: To reduce the risk of serious personal
injury, turn unit off, remove safety key, and
remove battery pack before making any
adjustments or removing/installing attachments
or accessories. An accidental start-up can
cause injury.
Installing and Removing the Battery Pack
(Fig. H)

DANGER: MAKE CERTAIN THE SAFETY KEY IS
REMOVED TO PREVENT ACTUATION BEFORE
REMOVING OR INSTALLING BATTERY.
nOTE: For best results, make sure the battery pack is
fully charged.
To Install Battery Pack
1. Lift and hold the battery port cover 
battery port 
 23 
.
2. Slide a battery pack 
into the battery port until an
 19 
audible click is heard (Fig. H). Make sure the battery pack
is fully seated and fully latched into position.
3. Close the battery port cover. Ensure the cover is fully
closed before starting mower.
To Remove Battery Pack
1. Open the battery port cover 
2. Depress the battery release button 
pack and pull battery pack 
and slide the mulching
22
 9 
up to expose the
as described above.
 9 
 20 
on the battery
 19
out of tool.
Fig. H
9
19
READ THIS INSTRUCTION MANUAL
BEFORE OPERATING YOUR MOWER
Refer to Figure A at the beginning of this manual for a complete
list of components. Save this manual for future reference.

DANGER: Sharp moving blade. Do not operate
the mower in mulching mode if the rear door is not
closed under spring tension as serious injury could
result. Take your mower to the nearest service center
for repair.

DANGER: Do not operate mower unless handle is
locked into position.

DANGER: Sharp moving blade. Never operate the
mower in bagging mode unless the hanger hooks on
the grass catcher are seated properly on the mower and
the rear discharge door rests firmly against the top of
the grass catcher as serious injury could result.

WARNING: Let the mower work at its own pace. Do
not overload.
Adjusting Mower Height (Fig. I)
The height of cut is adjusted by the cut height adjust lever.
nOTE: If you are not sure which height to cut, begin
mowing with the cut height adjustment lever 
positioned towards the rear of the appliance and adjust the
height down as needed, as shown in Fig. I.
To Set the Height of Cut
1. Pull the cut height adjustment lever 
locking notch 
 17 
.
2. Move the lever towards the rear of the appliance to raise
the height of cut.
3. Move the lever towards the front of the appliance to
lower the height of cut.
4. Push the height adjustment lever into one of the
locking notches.
English
20
23
 10 
 10 
out of the
9

Publicité

loading