Introduction - Cameo F1 T Manuel D'utilisation

34. Please keep a distance of at least 0.5 m to any combustible materials.
35. Power cables to power multiple devices must have a cross-section of at least 1.5 mm². Within the EU, the cables must correspond to
H05VV-F, or similar. Suitable cables are offered by Adam Hall. With these cables, you can connect multiple devices via the power OUT con-
nection to the power IN connection of an additional device. Make sure that the total current consumption of all connected devices does not
exceed the specified value on all connected devices (label on the device). Make sure to keep power cable connections as short as possible.
The warning triangle with lightning symbol indicates dangerous uninsulated voltage inside the unit, which may cause an
electrical shock.
The warning triangle with exclamation mark indicates important operating and maintenance instructions.
Warning! This symbol indicates hot surfaces. Specific housing parts can become hot during operation. Allow the device to cool for
at least ten minutes after use. Only then can it be transported or touched.
Warning! This device is designed for use below 2000 metres in altitude.
Warning! This product is not intended for use in tropical climates.
Caution! Intense LED light source! Risk of eye damage. Do not look into the light source.
CAUTION! IMPORTANT INFORMATION ABOUT LIGHTING PRODUCTS!
1. Do not stare, even temporarily, directly into the light beam.
2. Do not look at the beam directly with optical instruments such as magnifiers.
3. Strobe effects can trigger epileptic seizures in susceptible individuals! People with epilepsy should therefore avoid places where strobe
effects are used.

INTRODUCTION

CONTROL FUNCTIONS
1-channel, 2-channel 1, 2-channel 2, 3-channel, 4-channel and 5-channel DMX-functions
Master/Slave operation
Standalone functions
FEATURES
15.4° to 54.3° beam angle, manual zoom. 150 mm Fresnel lens. Configurable PWM frequency (flicker-free). DMX-512 control. RDM-
enabled. Manual control. Quicklight function. 4 dimmer curves. 16-bit dimming. Master/slave mode. Extremely quiet operation thanks to
heat pipe cooling and fan. Operating voltage: 100–240 V AC / 50–60 Hz. Power consumption: 87 W. Mounting bracket, filter frame, and
8-way barn door included. DC input for battery operation (11–17 V). Adapter for V-mount batteries optionally available.
LIGHT SOURCE CLF1T
1 x High Power 78 W Tungsten-LED (warm white).
LIGHT SOURCE CLF1D
1 × High Power 78 W daylight LED (cold white).
Both spotlights feature the RDM standard (remote device management). Remote device management allows the user to view status and
configuration of RDM terminals via an RDM-capable controller.
4
CAUTION:
To reduce the risk of electric shock, do not remove cover (or back). There are no user serviceable parts
inside. Maintenance and repairs should be exclusively carried out by qualified service personnel.