Elettro CF BOOSTER 3100 Mode D'emploi page 5

INSTRUCTIONS FOR USE
WARNING: BEFORE ITS FIRST USE, THE BOOSTER SHOULD BE CHARGED AT LEAST FOR 48
HOURS CONSECUTIVELY
Using for emergency starts.
1. Protect your eyes from any accidents.
2. Select the voltage of the battery of the vehicle to be started through the apposite manual connector
before you do any other operation.
3. Attach the red clamp + to the positive pole of the battery to be charged and the black clamp – to the earth
of the engine (car frame). Make sure that the two cables do not come into contact with fans, belts or other
moving parts.
4. When starting the engine stay away from the battery.
5. After getting the engine started, disconnect the black negative clamp first, then disconnect the red
positive clamp.
6. Replace the clamps in their special slots on the side of the appliance immediately.
Warning! If the engine does not start within 20 seconds, do not insist. Let the internal battery of the
BOOSTER cool down for at least 3 minutes, before trying to start the engine again. Strictly observe
this rule to prevent damage to the appliance.
Use as a power supply and a supplementary source of energy for vehicles.
To power the vehicle, connect the BOOSTER to the lighter socket, using the LESA 1 cable.
The BOOSTER is an essential instrument, taking the place of the car battery in all its applications. Many cars
have electronic components with a memory such as: alarm systems, on board computers, radio, telephone
etc; when replacing the battery these memories would be cancelled.
They can be saved by connecting BOOSTER to the lighter socket of the car using the LESA 1 cable, before
replacing the car battery.
Multipurpose source of supplementary energy.
The BOOSTER is a diversified source of portable energy for all 12V or 24V electrical appliances fitted with a
plug for car lighters. The electrical socket is protected up to 20A.
5