Auga WDS 1 Instructions D'utilisation page 18


If the spotlight is used out of the water, there must be sufficient
ventilation around the light. Do not build it into flammable material.

When used above water, keep at least 20cm clearance from the front of
the LED.

Max. immersion depth: 1 metre!

Max. water temperature 35°C.
Commissioning (figure 2, page 3)
This spotlight may only be built into the wall of a pond with a liner if you use the
wall set WDM-50 (article no. 901044, not supplied).

To install the WDM-50, follow the instructions supplied with the WDM-50
wall conduit (art. no. 901044, not included).

Outside the pond, glue a Ø 50mm glued socket (10) to the PVC pipe (8).

Mount the cable seal (11) 900mm from the plug (6) on the cable (9) of
the spotlight. Make sure that the half-moons (13 + 15) of the cable seal
(11) are positioned crosswise opposite one another with the rubber seal
(14) in between. Make sure that the bolts can be tightened outside the
pond.

Run the cable (9) plug (6) from outside of the pond through the PVC
glued socket (10), PVC pipe (8) and wall conduit (7).

Tighten the four bolts evenly with the supplied Allen key (12) until the
cord seal (11) creates a watertight seal around the glued socket (10)
and cord (9).

Turn the ring (1) of the water jet (5) and remove the ball bearing (3).
Remove the o-ring (4) from the water jet (5).

Run the plug (6) through the water jet (5) and connect the plug (6) to
the spotlight (2). Make sure that the plug (6) is tightened securely.

Slide the spotlight (2) into the water jet (5) and connect the ring (1) to
the water jet (5).

Fold the cable (9) in the PVC pipe (8) so that you can turn the water jet
(5) with spotlight (2) in the wall conduit (1) by inserting it in the wall
conduit (1) and turning it clockwise until it stops turning and is secured
in place (bayonet catch).
Connect the protruding cable to a suitable transformer. Thanks to the specified
installation depth (A), PVC pipe length (8) and cable length (9) dimensions, the
light can simply be replaced by taking it out of the water and inserting a new
lamp.
With different installation depths (A), the length of the PVC pipe (8) and cable (0)
must be modified.
Maintenance
Before carrying out work on the spotlight, remove the plug of the
corresponding transformer from the socket. Observe the safety
instructions.
Clean the light with warm water and a soft-bristle brush or rag. Make sure no
water gets inside the lamp housing.
Note: the LED has a long life service life, but is not replaceable
English
www.auga.nl 18