Berner BPT-TG CLEANING GUN FOAM B011 Notice D'utilisation page 12

Care and Maintenance
Pls. flush the head filling regular water in the cup and pressing the trigger for a while. With this
procedure you will avoid that the gaskets and filters dry out by the used cleaner when the item
is not in use.
Afterwards turn the green control switch into the horizontal "air only" position and press the
trigger to remove any remaining moisture out of the head.
Required Air Rate
To perform to its full potential, the Foam Gun requires a constant air pressure of 6 bar.
CAUTION:
Constant air rates vary depending on the size and power of the compressor.
Always make sure that the tank and the air hoses are free of impurities of any kind.
Explanation of the pictograms:
Always use face and eye-protection, breath-mask if necessary, protective gloves and
read / understand the instruction manual.
Technical Data
Air inlet
Air pressure
Air consumption
Weight
Serial number
1/4"
90 psi / 6,3 bar
188 l/min
0,67 kg
EN