Publicité
ASSEMBLY INSTRUCTIONS
1.
set the table down, make sure that the space beneath it
is clear of anything that can scratch the surface.
2. Unlock the undercarriage and raise the legs to a verti-
cal position.
3. Lower the T-Leg into position. Apply bolt plate to
junction of T-Leg and undercarriage. Insert bolt before
positioning washer and nut to tighten. Then, tighten
bottom bolt as well.
4. Twist the casters into the bottom of the T-Leg.
5. Re-lock the undercarriage into the storage position and
raise the table onto the wheels. Standing table up may
require two people! Please be careful and read
warning below.
WARNING: End legs (without casters) should be in locked,
storage position so that weight of the table is fully on the
undercarriage (with casters) during set up. Damage may
in the instructions.
All assembly instructions and all descriptions of bolts and
parts are given from the point of view of someone outside
looking inward.
NOTE: The two halves do not connect to one another. They
remain two separate pieces. You will apply the net to the
middle where they meet .
NET ASSEMBLY
1. Make sure table is in playing position before installing
the net. To do so, release the safety latch and carefully
lower each table half.
2. Attach one net clamp to the middle edge of where the
table halves meet. Repeat this with other net clamp on
opposite side. Then, slide net post into corresponding
clamp and repeat for the other side. Make sure the white
fabric of the net is on top. Use strings at either end of
the net to tighten the net and attach to base of net post
securely.
YOU ARE NOW READY
TO PLAY!
Publicité
