Bestron ABP604 Mode D'emploi page 16

operAtion
- general
The grill is only intended for domestic use, not for professional use.
6. 4. 1. 3.
5.
1. Handle
7.
2. Grill plate
3. Socket
4. Thermostat dial
5. Indicator light, temperature
before first use
1. Remove the grill from the packaging, and remove all packaging materials.
2. Clean the grill plate before using the appliance for the first time (see 'Cleaning and maintenance').
The appliance may emit a little smoke and a characteristic smell when you switch it on for the first time.
This is normal, and will soon stop. Make sure the appliance has sufficient ventilation.
Keep house birds away from the appliance when it is in use; fumes released from the non-stick
coating when the grill plate is hot can cause stress to birds.
Do not touch the appliance if it falls into water. Remove the plug from the wall socket immediately. Do
not use the device again.
use
- preheating
1. Put the appliance on a level and heat-resistant surface. Keep birds out of the area when using the
appliance.
2. Insert the thermostat fully into the grill-plate socket (see Figure 2).
Only the supplied cable with thermostat may be used.
3. Put the plug in the wall socket.
4. Adjust the thermostat dial to the required temperature (position 1
through 5). The indicator light on the thermostat will illuminate to
show that the heating element has been switched on.
Position Temperature (°C)
1 approx. 180°C
2 approx. 200°C
3 approx. 220°C
4 approx. 240°C
5 approx. 260°C
5. After waiting a few minutes check whether the indicator light is extinguished. Once the indicator light
has extinguished the appliance has reached the required temperature, and is ready for use.
During use the heating element will switch on and off to keep the temperature of the grill plate
constant. Consequently the indicator light will also occasionally be illuminated.
6. Removable thermostat
9.
7. Power cord with plug
8. Collecting groove and drip tray
9. Non-slip feet
16
instruction manual
2.
8.
5
Figure 2
1.
9.
Figure 1