Auto Standby; Apply Factory Settings - Sanyo FWSA205E Guide D'utilisation

When you watch movie late at night,
lowering volume level during loud sound
scenes, dynamic range will be pressed
down and you miss some dialogue and
narration. With this "Night Mode" you can
control volume level down but still can
enjoy fair level of audio tone and voice.
1
In any mode, Long press CLASSIC
on remote control for 3 seconds to
switch night mode on or off.
» The OPTICAL INPUT indicator
on the front panel of main unit
blinks three times when the night
mode is on.
» The OPTICAL INPUT indicator
on the front panel of main unit
blinks once when the night mode
is off.
Note
•
This product supports Dolby Digital and LPCM.
•
DTS is not supported.
•
Sampling frequency: 32KHz, 44.1KHz, 48KHz

5.5 Auto Standby

When playing media from a connected
device, the Sound Base automatically
switches to standby after 20 minutes if no
audio play from a connected device.
5.6 Apply factory
settings
You can reset your Sound Base to the
default settings programmed at the
factory.
1
On your remote control, press LINE
INPUT button.
2
Press MUSIC, VOL- and NEWS on
remote control within 3 seconds to
perform factory default settings.
» when the factory setting restore is
complete, the system shuts down
into standby mode and restart.
EN 11