Connect And Set Up; Position The Sound Base; Connections - Sanyo FWSA205E Guide D'utilisation

4 Connect and
set up
This section helps you connect
your Sound Base to a TV and other
devices, and then set it up.
For information about the basic
connections of your Sound Base
and accessories, see the Quick
Start Guide.
Note
•
For identification and supply ratings, see
the type plate at the back or bottom of
the product.
•
Before you make or change any
connections, make sure that all devices
are disconnected from the power outlet.
4.1 Position the
Sound Base
For best results, place your Sound
Base as shown below.
< 30 kg / 66.1 lbs
Note
•
The Sound Base is designed for TVs that
weigh no more than 30 kg / 66.1 lbs.
•
Do not install a CRT type TV on the Sound
Base.
•
Magnetized cards, watches, etc., can be
damaged if installed too close to this unit.
8 EN

4.2 Connections

4.2.1 Connect To TV
AUX IN
OPTICAL
IN
LINE IN
OPTICAL Cable
(not supplied)
BEST
AUDIO OUTPUT
or
HEADPHONE
OPTICAL OUTPUT
or
DIGITAL AUDIO OUT (OPTICAL)
If your TV does not have audio outputs shown left,
to connect the Sound Base directly to your other
devices (Blu-Ray player, game system, etc.)
see your device' s user manual.
Note
•
Make sure the unit is Turned Off when
connecting.
•
Check whether the connection for all cables
are connected tightly.
•
If you connect with a Line-in cable, make
sure the volume for the headphone output is
appropriate for the Sound Base input.
•
If the Line-in volume is too soft, the
Sound Base may not output sounds with
appropriate volume.
4.2.2 Plug the AC plug into an
electrical outlet.
4.2.3 Turn Sound Base on
Please refer to "Play audio through
Bluetooth" on 5.3 when you use Bluetooth.
GOOD