Climadiff CLE18 Notice D'utilisation page 48

10. TROUBLE SHOOTING
You can solve many common Wine cooler problems easily, saving you the cost of a possible service call.
Try the suggestions below to see if you can solve the problem before calling the servicer.
PROBLEM
Wine cooler does not operate
Wine cooler is not cold enough
Turns on and off frequently
The light does not work
Vibrations
The wine cooler seems to make too much noise
The door will not close properly
Error code E1 or E2
Replacing light
This appliance consists of light-emitting diodes (LEDs). This type of diode cannot be changed by the
consumer. The lifetime of these LEDs is normally sufficient for no change to be made. If however, and
despite all the care taken during the manufacture of your wine cellar, the LEDs were defective, please
contact your after-sales service for any intervention.
POSSIBLE CAUSE

Not plugged in

The appliance is turned off

The circuit breaker tripped or a blown fuse

Check the temperature control setting

External environment may require a higher
setting

The door is opened too often

The door is not closed completely

The door gasket does not seal properly

The room temperature is hotter than normal

A large amount of contents has been added to
the wine cooler.

The door is open too often

The door is not closed completely

The temperature control is not set correctly

The door gasket does not seal properly

Not plugged in

The circuit breaker tripped or a blown fuse

The bulb has burned out, contact your after-
sales service

The light switch is "OFF"

Check to assure that the wine cooler is level

The rattling noise may come from the flow of
the refrigerant, which is normal

As each cycle ends, you may hear gurgling
sounds caused by the flow of refrigerant in your
wine cooler

Contraction and expansion of the inside walls
may cause popping and crackling noises

The wine cooler is not level

The wine cooler is not level

The door was reversed and not properly
installed

The gasket is dirty

The shelves are out of position
 Sensor problem, contact your retailer's after
sales department
48