ADVANCED FEATURES
STANDBY
Press the STANDBY button for 2 seconds until the light turns red, the keyboard will enter Standby
mode:
No MIDI data will be sent when the keyboard is in Standby mode.
Hold the STANDBY button again to restore normal operational status. The light will return to blue and
MIDI data can then be sent again after about 5 seconds.
OCTAVE SHIFT
You can shift the keyboard pitch in octaves by pressing the OCTAVE +/- buttons.
When the octave is shifted, the relevant octave button indicator will be lit.
The highest note number will not be larger than 127 and the lowest note number will not be lower than
0 after the octave shifting. Press the two octave buttons at the same time to reset the octave shift to
00, and the indicator will turn off.
This feature is also available in Split mode.
When you re-enter the octave shift mode, the further change will be based on the previous setting but it
will be reset after power off.
The keyboard ranges of LIVE series are shown below:
PITCH BEND AND MODULATION WHEELS
Use the pitch wheel to send pitch bend messages. Move this up to raise the pitch; move this down to
lower the pitch. It will return to center position automatically when you release the wheel to have no
pitch bend.
Use the modulation wheel to send modulation messages. The bottom position of the wheel
corresponds to no-modulation effect and the top position corresponds to Max. Modulation effect.
CONTROL DIAL
Use the dial to change and send MIDI control data. Rotate the dial clockwise to increase data and
rotate counter clockwise to decrease data. The default control is set to send program change
messages.
It can also change other data such as Bank LSB, Bank MSB etc.
Control range of the dial is 0-127
The dial cannot be used to change the MIDI channel or to select curves.
PROGRAM CHANGE
Press the PROG button and its indicator will light up.
Rotate the CONTROL dial to change the program.
When you re-enter the program change mode, the further change will be based on the previous
setting. This will be reset after power off.
LIVE49
LIVE61
LIVE88
5