Steba VK 7 Mode D'emploi page 12

∙ This appliance is intended to be used in household and similar
applications such as:
o staff kitchen areas in shops, offices and others working
environments
o by clients in hotels, motels and other residential type en-
vironments
o bed and breakfast type environments.
∙ If an extension cable is used, it has to have a cross-section of
1,5mm². A cable drum must always be unwound.
∙ If a GS-tested 16 A multi-pin extension is used, it may not be
charged with more than 3680 watts due to fire hazard.
∙ Make sure that children do not tease the cable or that a trip
hazard occurs.
∙ The device must always be disconnected from the power supply
if it is not supervised and before assembling, disassembling or
cleaning.
∙ The device is not intended for continuous use, always al-
low to cool between sealing operations.
Cleaning
Attention! Pull the plug before cleaning and allow
∙
the device to cool down.
∙ Never immerse the unit into water.
∙ Hygiene: Please always clean the device to avoid bacteria and
mold formation.
∙ Remove the lower seal of the vacuum chamber and the upper
contact seal out of the and clean in warm soapy water and leave
to dry.
∙ Wipe the other parts with a damp cloth with detergent and
dry. Do not use abrasive detergents.
∙ Ensure that the upper welding strip and the upper seal are
not damaged.
∙ Carefully install the lower two seals.
∙ Ensure that no liquids enter the vacuum extractor when clean-
ing.
12