Operation - Domair kFC-817a Manuel D'utilisation

fresh and clean. never use anything
other than water.
- To avoid the risk of unpleasant
odours: empty the tank completely
and clean it at least once a week;
stop the humidifying function for
15 minutes before switching off the
ventilation.
- The water level should never be below
the «Min» level (risk of damage to the
pump), and never above the «Max»

OPERATION

Connect the appliance to the power
supply. the light
that the appliance is connected to the
power supply.
Press the button
appliance. After starting, it can then be
controlled as follows:
Button : selection of fan speeds. By
default, the medium speed is automa-
tically selected when the appliance is
turned on. Then each time the button is
touched, speeds are selected according
to the following cycle: medium, high,
Rev 0-25 11 19
comes on to show
to start or stop the
Fabriqué en Chine
level (risk of overflow).
- The freezer blocks should be placed in
the freezer before being used.
- Never leave water in an appliance
which is not being used.
- In case of prolonged non-use, drain
the appliance completely (see para-
graph MaintenanCe). If this ins-
truction is not respected, the war-
ranty does not apply.
low, medium, etc. The corresponding
light on the display panel comes on.
Button : selection of normal, natural
or night mode. By default, the normal
mode is automatically selected when
the appliance is switched on. The light
corresponding to the selected mode on
the control panel comes on.
- normal mode : the unit will operate
according to the selected fan speed.
- natural mode
is reproduced by randomly alternating
: natural ventilation
Page 26